Get started

Monitor Audio Bronze AMS 7G

Height speaker · Bronze 7G series

Drag to turn the model. It is built from the published dimensions, not a photo.

The Monitor Audio Bronze AMS 7G is an 8 Ω height speaker rated 86 dB (2.83 V, 1 m), with a recommended 10–60 W amplifier. Of the 29 receivers and amps in our catalogue, 27 are rated to drive it and 2 are not recommended.

$779 a pair (MSRP, September 2026)

Check it with your receiverSee it in your room

We earn a commission when you buy through these links. It never affects which products we show or recommend. Disclosure

Used on eBay

Receivers and amplifiers for the Bronze AMS 7G

Each pairing is checked by our compatibility engine: the speaker's impedance against the amplifier's rated minimum, and height decoding for height speakers. Whether it plays loud enough depends on how far you sit, which the 3D editor works out for your room.

Rated to drive it (27)

Not recommended (2)

  • Denon AVR-S570BT

    Denon AVR-S570BT has no Dolby Atmos or DTS:X decoding for height speakers.

  • Denon AVR-S670H

    Denon AVR-S670H has no Dolby Atmos or DTS:X decoding for height speakers.

Bronze AMS 7G specifications

Impedance8 Ω
Sensitivity86 dB (2.83 V, 1 m)
Low end83 Hz
Drivers1 × 25 mm, 1 × 102 mm
Size7×7×12 in
Recommended amplifier power10–60 W
Weight3.1 kg (6.8 lb)
MSRP$779 a pair (MSRP, September 2026)

Every value comes from the sources under References, last retrieved September 15, 2026. To check it against the rest of your system, use the compatibility checker.

Questions about the Bronze AMS 7G

What receiver do I need for the Bronze AMS 7G?
One rated for 8 Ω speakers. In our catalogue, Emotiva BasX A-700, Yamaha RX500A and Denon AVR-X1700H are rated to drive it. Denon AVR-S570BT and Denon AVR-S670H are not rated for it.
Is the Bronze AMS 7G 4 ohm or 8 ohm?
The Monitor Audio Bronze AMS 7G has a nominal impedance of 8 Ω. Use a receiver or amplifier rated down to 8 Ω or lower.
How much power does the Bronze AMS 7G need?
Monitor Audio recommends an amplifier of 10–60 W. Its sensitivity is 86 dB (2.83 V, 1 m). How much of that you use depends on how far you sit and how loud you listen, which the 3D editor works out for your room.
How low does the Bronze AMS 7G go?
The Monitor Audio Bronze AMS 7G is rated down to 83 Hz. Below that, a subwoofer takes over; where the bass actually lands depends on your room's modes.
How big is the Bronze AMS 7G?
The Monitor Audio Bronze AMS 7G measures 185 × 173 × 302 mm (7.3 × 6.8 × 11.9 in, width × height × depth) and weighs 3.1 kg (6.8 lb).

Similar products

References

  1. Monitor Audio Bronze AMS 7G: Manufacturer product page, monitoraudio.com, retrieved September 15, 2026
  2. Monitor Audio Bronze AMS 7G: Retailer listing, upscaleaudio.com, retrieved September 15, 2026

Brand names are trademarks of their owners. Not affiliated with or endorsed by any manufacturer. 3D models are our approximations. Prices are manufacturer list prices (MSRP) as of the month shown. How we earn from buy links: affiliate disclosure.