Start

Polk Monitor XT60

Monitor XT series

The Polk Monitor XT60 is a tower speaker with 8 Ω impedance and 86 dB sensitivity. Every receiver and amp in our catalogue can drive it.

Impedance
8 Ω
What the receiver must be rated for
Sensitivity
86 dB
Higher is louder per watt
Amplifier power
25–200 W
Polk's recommendation
Bass extension
38 Hz
How low it plays

$229 each (MSRP, September 2026)

Check it with your receiverSee it in your room
3D model of the Polk Monitor XT60

Drag to turn it. Built from the published dimensions, not a photo.

We earn a commission when you buy through these links. It never affects which products we show or recommend. Disclosure

Used on eBay

Which receivers and amps can drive it?

What decides it is impedance: the Monitor XT60 is 8 Ω, and the receiver or amp has to be rated for that.

  • Works

    Receivers and amps rated for 8 Ω

    29 in our catalogue

In its price range

All 29 receivers and amps we checked

Works29

Which center speaker matches it?

For the closest tonal match as voices move across the front, pick a center from the same Monitor XT series.

Plan your room around the Monitor XT60.

Draw your room in 3D, place the Monitor XT60 and see how they sound at your seat, with every connection to your receiver checked. Designing is free.

Build it in your room

Monitor XT60 specifications

Impedance
8 Ω
Sensitivity
86 dB
Low end
38 Hz
Drivers
1 × 25 mm, 1 × 165 mm, 2 × 165 mm
Size
7×36×9 in
Recommended amplifier power
25–200 W
Weight
9.07 kg (20 lb)
MSRP
$229 each (MSRP, September 2026)

Every value comes from the sources under References, last retrieved September 15, 2026. To check it against the rest of your system, use the compatibility checker.

Questions about the Monitor XT60

What receiver do I need for the Monitor XT60?
One rated for 8 Ω speakers. In our catalogue, Denon AVR-S570BT, Emotiva BasX A-700 and Yamaha RX500A are rated to drive it.
Is the Monitor XT60 4 ohm or 8 ohm?
The Polk Monitor XT60 has a nominal impedance of 8 Ω. Use a receiver or amplifier rated down to 8 Ω or lower.
How much power does the Monitor XT60 need?
Polk recommends an amplifier of 25–200 W. Its sensitivity is 86 dB. How much of that you use depends on how far you sit and how loud you listen, which the 3D editor works out for your room.
How low does the Monitor XT60 go?
The Polk Monitor XT60 is rated down to 38 Hz. Below that, a subwoofer takes over; where the bass actually lands depends on your room's modes.
How big is the Monitor XT60?
The Polk Monitor XT60 measures 190.5 × 925 × 230.8 mm (7.5 × 36.4 × 9.1 in, width × height × depth) and weighs 9.07 kg (20 lb).

Similar products

References

  1. Polk Monitor XT60: Spec sheet, denon.com, retrieved September 15, 2026
  2. Polk Monitor XT60: Manufacturer product page, polkaudio.com, retrieved September 15, 2026

Brand names are trademarks of their owners. Not affiliated with or endorsed by any manufacturer. 3D models are our approximations. Prices are manufacturer list prices (MSRP) as of the month shown. How we earn from buy links: affiliate disclosure.