Get started

Bowers & Wilkins 607 S3

Bookshelf speaker · 600 Series series

Drag to turn the model. It is built from the published dimensions, not a photo.

The Bowers & Wilkins 607 S3 is an 8 Ω bookshelf speaker rated 84 dB (2.83 V, 1 m), with a recommended 30–100 W amplifier. Of the 29 receivers and amps in our catalogue, 29 are rated to drive it.

$1,000 a pair (MSRP, September 2026)

Check it with your receiverSee it in your room

We earn a commission when you buy through these links. It never affects which products we show or recommend. Disclosure

Used on eBay

Receivers and amplifiers for the 607 S3

Each pairing is checked by our compatibility engine: the speaker's impedance against the amplifier's rated minimum, and height decoding for height speakers. Whether it plays loud enough depends on how far you sit, which the 3D editor works out for your room.

Rated to drive it (29)

607 S3 specifications

Impedance8 Ω
Sensitivity84 dB (2.83 V, 1 m)
Low end52 Hz
Drivers1 × 25 mm, 1 × 130 mm
Size6×12×8 in
Recommended amplifier power30–100 W
Weight4.65 kg (10.3 lb)
MSRP$1,000 a pair (MSRP, September 2026)

Every value comes from the sources under References, last retrieved September 15, 2026. To check it against the rest of your system, use the compatibility checker.

Questions about the 607 S3

What receiver do I need for the 607 S3?
One rated for 8 Ω speakers. In our catalogue, Denon AVR-S570BT, Emotiva BasX A-700 and Yamaha RX500A are rated to drive it.
Is the 607 S3 4 ohm or 8 ohm?
The Bowers & Wilkins 607 S3 has a nominal impedance of 8 Ω. Use a receiver or amplifier rated down to 8 Ω or lower.
How much power does the 607 S3 need?
Bowers & Wilkins recommends an amplifier of 30–100 W. Its sensitivity is 84 dB (2.83 V, 1 m). How much of that you use depends on how far you sit and how loud you listen, which the 3D editor works out for your room.
How low does the 607 S3 go?
The Bowers & Wilkins 607 S3 is rated down to 52 Hz. Below that, a subwoofer takes over; where the bass actually lands depends on your room's modes.
How big is the 607 S3?
The Bowers & Wilkins 607 S3 measures 165 × 300 × 207 mm (6.5 × 11.8 × 8.1 in, width × height × depth) and weighs 4.65 kg (10.3 lb).

Similar products

References

  1. Bowers & Wilkins 607 S3: Spec sheet, bowerswilkins.com, retrieved September 15, 2026
  2. Bowers & Wilkins 607 S3: Manufacturer product page, bowerswilkins.com, retrieved September 15, 2026

Brand names are trademarks of their owners. Not affiliated with or endorsed by any manufacturer. 3D models are our approximations. Prices are manufacturer list prices (MSRP) as of the month shown. How we earn from buy links: affiliate disclosure.