Start

Sonus faber Lumina Center I

Lumina series

The Sonus faber Lumina Center I is a center channel speaker with 4 Ω impedance and 87 dB sensitivity. 28 of the 29 receivers and amps in our catalogue can drive it, 14 of them once set to 4 Ω.

Impedance
4 Ω
What the receiver must be rated for
Sensitivity
87 dB
Higher is louder per watt
Amplifier power
30–100 W
Sonus faber's recommendation
Bass extension
65 Hz
How low it plays

$1,000 each (MSRP, September 2026)

Check it with your receiverSee it in your room
3D model of the Sonus faber Lumina Center I

Drag to turn it. Built from the published dimensions, not a photo.

We earn a commission when you buy through these links. It never affects which products we show or recommend. Disclosure

Used on eBay

Which receivers and amps can drive it?

What decides it is impedance: the Lumina Center I is 4 Ω, and the receiver or amp has to be rated for that.

  • Works

    Receivers and amps rated for 4 Ω

    14 in our catalogue

  • Needs a setting change

    Receivers with a 4 Ω setting

    Set the receiver to 4 Ω in its speaker setup.

    14 in our catalogue

  • Not recommended

    Receivers not rated for 4 Ω

    1 in our catalogue

In its price range

All 29 receivers and amps we checked

Works14

Needs a setting change14

Set the receiver to 4 Ω in its speaker setup.

Not recommended1

Sonus faber Lumina Center I is 4 Ω; Denon AVR-S570BT supports 6 Ω and up.

Plan your room around the Lumina Center I.

Draw your room in 3D, place the Lumina Center I and see how they sound at your seat, with every connection to your receiver checked. Designing is free.

Build it in your room

Lumina Center I specifications

Impedance
4 Ω
Sensitivity
87 dB (2.83 V, 1 m)
Low end
65 Hz
Drivers
1 × 29 mm, 2 × 120 mm
Size
21×7×8 in
Recommended amplifier power
30–100 W
Weight
7.6 kg (16.8 lb)
MSRP
$1,000 each (MSRP, September 2026)

Every value comes from the sources under References, last retrieved September 15, 2026. To check it against the rest of your system, use the compatibility checker.

Questions about the Lumina Center I

What receiver do I need for the Lumina Center I?
One rated for 4 Ω speakers. In our catalogue, Emotiva BasX A-700, Monoprice M7100X and Onkyo TX-NR6100 are rated to drive it. Yamaha RX500A, Denon AVR-S670H and Denon AVR-X1700H work once the receiver's impedance setting is changed to 4 Ω. Denon AVR-S570BT is not rated for it.
Is the Lumina Center I 4 ohm or 8 ohm?
The Sonus faber Lumina Center I has a nominal impedance of 4 Ω. Use a receiver or amplifier rated down to 4 Ω or lower.
How much power does the Lumina Center I need?
Sonus faber recommends an amplifier of 30–100 W. Its sensitivity is 87 dB (2.83 V, 1 m). How much of that you use depends on how far you sit and how loud you listen, which the 3D editor works out for your room.
How low does the Lumina Center I go?
The Sonus faber Lumina Center I is rated down to 65 Hz. Below that, a subwoofer takes over; where the bass actually lands depends on your room's modes.
How big is the Lumina Center I?
The Sonus faber Lumina Center I measures 523 × 168 × 212 mm (20.6 × 6.6 × 8.3 in, width × height × depth) and weighs 7.6 kg (16.8 lb).

Similar products

References

  1. Sonus faber Lumina Center I: Manufacturer product page, sonusfaber.com, retrieved September 15, 2026
  2. Sonus faber Lumina Center I: Retailer listing, worldwidestereo.com, retrieved September 15, 2026
  3. Sonus faber Lumina Center I: Retailer listing, paragonsns.com, retrieved September 15, 2026

Brand names are trademarks of their owners. Not affiliated with or endorsed by any manufacturer. 3D models are our approximations. Prices are manufacturer list prices (MSRP) as of the month shown. How we earn from buy links: affiliate disclosure.